Drager Chip Management System ( CMS )

Call us now on 01200 445804
or Email info@ribble-enviro.co.uk

Portable Gas Detectors
Confined Space 4 Gas Monitors
Single Gas
Limited life instruments (Disposable Gas Detectors)
Single gas (plus PID)
Multi gas
Multi gas (plus PID)
Photo ionisation detectors (PID)
Leak detectors (PPB)
Leak detectors (PPM)
Benzene detectors
Refrigerant leak detectors
Carbon dioxide CO2 (infrared)
Hydrogen monitor
Hydrocarbon HC (infra red)
Carbon monoxide CO detectors
Indoor air quality instruments
Portable Methane Detector
UltraSonic Leak Detection
Fixed Gas Detection
Honeywell Fixed Gas Detection
Riken Keiki Fixed Gas Detection
GDS Technologies Fixed Gas Detection
Ribble GD Fixed Gas Detection
Bacharach Fixed Gas Detection
Crowcon Fixed Gas Detection
Interscan Fixed Gas Detection
Fixed Gas Detection Systems
Single Point
1-4 channel
1-10 channel
Addressable sytems up to 32
Addressable systems up to 64
Sampling Systems
PID fixed
Drager Fixed Gas Detection Monitoring
Refrigerant Fixed Gas Detection
Honeywell Fixed Gas Detection Systems
Area Monitoring Devices
Area Monitoring
Landfill Gas Analyser
Landfill Gas Analysers
Wireless Gas Detection Systems
Gas Detection Tubes
Detection Tubes
Sub Slab Monitoring
The Vapor Pin System
RAE Systems Spares & Accesories
MiniRAE 2000 PID Spares
MiniRAE 3000 PID Spares
QRAE II spares
EntryRAE Spares
UltraRAE 3000 Spares
Replacement RAE Sensors
Replacement Gas Monitors Sensors
Replacement Drager Spares & Sensors
Replacement Crowcon Spares & Sensors
Replacement BW Spares & Sensors
Gas Detection Badges
TDI/MDI Badges
Gas Detection Badges
Calibration Systems
Calibration Systems and Kits
Fumigation Products
Fumigation Monitor
Calibration Gas
Calibration Gas Regulator
Water Quality Meter
YSI Pro Plus Quattro
Temperature and Pressure Calibrators
Temperature Calibrators
Digital Pressure Calibrator
Pressure Calibrator
Marine Test Case
Pressure Pumps
Digital Pressure Meter
Smoke Emissions
Oil Mist Detector
Oxygen Analysers
NOx Emissions
Water Monitoring
Personal Protection Equipment
MSA Gallet F1 XF Safety Helmet
Dust Monitoring Devices
Dust Monitoring

Special Offer

On All Orders over £100 and £500

● Spend over £100.00 and receive a FREE Single person 1st Aid Kit and ERGO Safety Glasses

● Spend over £500.00 and receive 2 x FREE 1st Aid Kits & 2 pairs of Safety Glasses

Drager Chip Management System ( CMS )

£50.58ex. VAT £60.70 inc. VAT

Key Features:

  • Fast response — results in 20 seconds
  • No warm-up required
  • TWA and action levels reported within 1 to 2 minutes
  • Highly accurate
  • Accuracy ± 4 to 7% of measured value for most gases
  • Consistent flow maintained and corrected for changes in atmospheric pressure
  • Measures low levels, even benzene
  • Not subject to human error and bias
  • Simple 1, 2, 3, operation
  • Minimal training required
  • Concentration displayed on easy-to-read backlit digital readout in any one of four languages
  • No calibration gas required
  • Calibration information is stored on each CMS chip
  • System integrity assured
  • Electronic system self-test performed upon start-up
  • Sampling system test performed before each test
  • No battery charging
  • Operates on AA alkaline batteries for more than 7 hours of measurement
  • Ready for instant use — ideal for emergency response
  • Internal data recorder
  • Stores up to 50 measurements
  • Data includes time/date, contaminant/concentration, and sequential number of measurement series
  • User may enter measurement location
  • Recall and display data on demand


The direct-reading Dräger Chip Measurement System (CMS) combines chemical-specific chips and an electronic analyzer for highly accurate and reliable gas and vapor measurements. With the flip of a switch, the Dräger CMS provides quick results that appear on an easy-to-read LCD. The Dräger CMS is ideal for industries where glass tubes cannot be used, or where it is not cost-effective to keep a monitor on-hand that requires sensors and calibration.Each Dräger CMS chip contains 10 capillaries (10 test) filled with substance-specific reagent. A barcode on the chip is read by the analyzer optics to obtain information such as gas type, measuring range, and required measuring time. Gas type, part number, and batch number are printed on the chip for user convenience.

CMS Chips are interchangeable without calibration. Chip calibration remains valid for two years. One 10-test chip is approximately the same cost as a box of detector tubes.The analyzer contains a pump mechanism, microprocessor, optics, and software. The optics read the barcode on an inserted chip and menu-driven instructions for the test appear on the analyzer’s LCD. Each analyzer includes a data recorder that will hold the last 50 determinations in memory along with the time/date of sample and a location code.




There are no reviews yet.

Be the first to review “Drager Chip Management System ( CMS )”


I will be needing the following options … *

Please select a maximum of 30 options.